Installation; Before You Begin - Jensen MSR2007 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLATION

Before You Begin

Before you begin, always disconnect the battery negative terminal.
Important Notes
Before final installation, test the wiring connections to make sure the unit is connected
properly and the system works.
Use only the parts included with the unit to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to your vessel.
Install the unit where it does not interfere with driving and cannot injure passengers if
there is a sudden or emergency stop.
Avoid installing the unit where it will be subject to high temperatures from direct sunlight,
hot air, or from a heater, or where it would be subject to excessive dust, dirt or vibration.
Wired Commander Mounting
1.
Choose a mounting area for the wired commander that is clean and flat, allowing the rear
gasket to fully seal to the mounting surface.
2.
Secure the wired commander using either of the recommended mounting methods
detailed in the diagrams below.
M4 MOUNTING SCREWS (4-PCS)
MINIMUM SCREW LENGTH 1 1/2"
MSR2007
7/8" HOLE REQUIRED
FOR CABLE
M5X8 SCREWS REQUIRED FOR MOUNTING
MAXIMUM SCREW DEPTH IN COMMANDER 1/4"
7/8" HOLE REQUIRED FOR CABLE
Tabla de contenido
loading

Tabla de contenido