JVC TS-C50P2G Instrucciones De Montaje página 4

3. Adjusting the angle of the wall-hanging bracket
5° tilt
Stay
4. Prepare the Wide Plasma Display.
• Attach the insulating spacers to the display.
Remove the four bolts.
N o t e
Note
• Place the display face down on top of a cloth which is clean and free from other foreign particles, and then carry out the
procedure above.
All manuals and user guides at all-guides.com
15° tilt No tilt
The angle for this wall-hanging bracket can be
adjusted to one of five positions ranging from
no tilt to 20° tilt in steps of 5°.
At the time of shipment from the factory, the angle of
tilt is set to 5°. To change this angle, you should
change the installation position of the stay.
* The stay is not needed if installing the
display with no tilt.
Angle adjustment positions
5° tilt
10° tilt
15° tilt
20° tilt
No tilt
1. Remove the four bolts from the
display.
2. Use the accessory tool (Allen key) to
install the four accessory pan head
bolts with hex socket, toothed pan
washers and insulating spacers into
the holes where the four bolts used to
be as shown in the illustration.
Pan head bolt wih hex socket
Toothed pan washer
Insulating spacer
11