Blade Sharpening; Troubleshooting - Fimar H/220 Manual Del Usuario

K-V VERTICAL
SLICERS
ATTENTION
Maintenance operations should always be performed with the machine unconnected
from the power supply and, if another position is not specifically requested, with the
slice thickness adjustment knob in "0".
Maintenance operations that should only be performed by personnel authorised by the
manufacturer are the following:
•Blade replacement;
•Sharpener grinding wheels replacement;
•Motor transmission belt replacement;
•Under the base electrical system components replacement;
GB
•Structural repairs, under the base components repairs.

BLADE SHARPENING

Carefully clean the machine as reported in the previous paragraphs before continuing
with the operations.
ATTENTION
The sharpening can be done until a 12 mm decrease of the nominal value of the blade
diameter.
Beyond this value THE BLADE MUST BE REPLACED. The replacement MUST be
done by personnel authorised by the manufacturer.

TROUBLESHOOTING

The purpose of the following information is to help the operator to identify and correct
any anomalies or malfunctions that may occur during use.
If one of the faults listed in the table occurs, inform the manufacture to actively contrib-
ute in developing new solutions and improving construction techniques.
- 19 - English language