Technical Data - Hansgrohe Adoro 14862000 Manual Del Usuario

The fitting must installed, flushed and tested
after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in posi­
tion on the sink.
3. Slip the plastic washer, the slide washer, the metall
washer and collar nut over the hose and threaded
base and tighten the collar nut by hand. If there is
not enough space, please use only the slide washer
and the metall without the plastic washer.
4. Tighten screws.
5. Connect the connecting hose / supply pipes to the
angle valves;
cold right ­ hot left.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is activated by pulling the lever handle.
Turning to the left = cooler water,
turning to the right = warmer water.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow by 0.3 MPa:
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0.15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.

English
Spare parts (see page 3)
1
1.1
2
3
4
5
6
7
8
9
max. 1 MPa
0.1 ­ 0.5 MPa
1.6 MPa
max. 80° C
65° C
13 l/min
llever head
screw cover
flange
nut
cartridge cpl.
aerator cpl.
fixation cpl.
connection hose 900 mm
spout cpl.
sealing set
97400000
96338000
96468000
96461000
92730000
13913000
95049000
98785000
92830000
92646000