Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
6.2.4.
Cleaning of filter
Replace the filter brushes/sponges (4/5) regularly (1 x per season).
If you notice a deterioration in water quality, a decreased delivery rate or water escaping from the cover, take
the following steps:
1) The larger dirt particles collect on the bottom of the filter housing chambers. They can be removed
using the dirt discharge tap (8) as follows:
→ Leave the pump operating.
→ Open the discharge taps (8) for around 10 seconds and then switch the pump off until all filter
chambers are completely empty.
→ Switch the pump on again in order to remove further dirt particles from the bottom, allow the water to
flow from every discharge tap (8) until it runs clear and then close the tap on each filter chamber.
→ If a dirt discharge tap (8) is blocked, remove the foreign objects from inside the tap.
2) Mechanical biological filter: Take the filter brushes / filter sponges (4/5) out of the filter and rinse them
under running water. Then re-insert the filter brushes / sponges (4/5) correctly into the filter housing (8).
3) Biological filter: The filter granulate (6) must be replaced when it disintegrates severely.
4) Check whether the filter outlet (7) is free.
Annual maintenance: Carefully clean the filter at least once per year.
Empty the filter completely. Remove the dirt and debris from the bottom. Rinse out all filter materials with
water.
Winter - maintenance
Protect your pond filter from freezing!
If there is danger of freezing, take the pump out of your garden pond.
Completely clean the pump as specified in the instructions.
Store the pump over winter in a frost-free location.

7. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the
device was purchased. The warranty period begins with the day of the purchase and is subject to the
provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing
will be eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third
parties. Damage resulting from improper handling or operation, incorrect setting-up or storage, inappropriate
connection or installation or Acts of God or other external influences are excluded from warranty.
Parts subject to wear, such as the UV bulb and filter mats are excluded from the guarantee.
All parts were manufactured using maximum care and high-quality materials and are designed for a long
lifecycle. It should be understood, however, that the wear and tear depends on the kind of use, the intensity
of use and the internals of maintenance.
Complying with the installation and maintenance information contained in the present operating instructions
will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire
device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by wilful acts or negligence on the side
of the manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has to be
evidenced by the purchaser in the form of the submission of the sales receipt. The present warranty
commitment is valid in the country in which the device was purchased.
16
7
Tabla de contenido
loading

Este manual también es adecuado para:

Mts 30000 uv-c 24 inox

Tabla de contenido