Care And Maintenance; Usb Power Port; Troubleshooting - Black and Decker JUS500IB Manual De Instrucciones

Puente auxiliar de arranque de 500 amperios con compresor
Ocultar thumbs Ver también para JUS500IB:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PORTABLE COMPRESSOR
The built-in 12 volt DC compressor can be used to inflate all vehicle tires and recreational inflatables. An inflator
nozzel, sports needle and bicycle racing tire adapter (Presta Stem Adapter) are included. Each one of these
compressor adapters connect to the SureFit
®
nozzle connector at the end of the hose. The compressor adapters
are stored inside a small compartment near the compressor power switch. The Compressor On/Off Switch is
located on the front of the unit near the pressure gauge. The Air Pressure Gauge is located on the front of the
unit above the control panel. The compressor can operate long enough to fill up to 3 average sized tires before
the battery must be recharged.
The compressor may be used by removing the air hose from the storage hatch and if required, fitting an
appropriate nozzle to the air hose. Return hose to the storage compartment after use.
WARNING – TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Follow all safety
instructions found in the "Specific Safety Instructions For Compressors" section of this instruction
manual.
Inflating Tires or Products With Valve Stems
1. Screw the SureFit
nozzle connector onto the valve stem. Do not overtighten.
®
2. Turn on the Compressor Power Switch.
3. Check pressure with the pressure gauge.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Unscrew and remove the SureFit
®
nozzle connector from the valve stem.
6. Allow the unit to cool, then recharge before storing away.
7. Store the compressor hose and nozzle connector in the storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of one of the nozzle adapters.
1. Select the appropriate nozzle adapter (i.e, needle).
2. Screw the adapter into the SureFit
®
nozzle connector. Do not overtighten.
3. Insert the adapter into item to be inflated.
4. Turn on the Compressor Power Switch — inflate to desired pressure or fullness.
IMPORTANT NOTE: Small items such as volleyballs, footballs, etc. inflate very rapidly. Do not over-inflate.
5. When desired pressure is reached, turn off the Compressor Power Switch.
6. Disconnect the adapter from the inflated item.
7. Unscrew and remove the adapter from the SureFit
8. Allow the unit to cool, then recharge before storing away.
9. Store the compressor hose, nozzle connctor and adapter in the storage compartment.

USB POWER PORT

1. Push the USB Power Port On Pushbutton to turn the USB Port ON.
2. Plug the USB-powered device into the inverter's USB Charging Port and operate normally.
Notes:
This unit' s USB Power Port does not support data communication. It only provides 5 volts/500mA DC power to an external USB-
powered device. Make sure the USB Charging Port ON/OFF Pushbutton is in the OFF position when the unit is being recharged or
stored.
Some household USB-powered electronics will not operate with this unit.
LED AREA LIGHT
The Area Light is controlled by the Area Light Power Button on the front panel of the unit. Make sure the lamp is
turned OFF when the unit is being recharged or stored.

TROUBLESHOOTING

Problem
Solution
Unit will not charge
• Make sure the power switch is in the off position.
• Make sure a suitable gage extension cord is properly connected to
both the unit and a functioning AC outlet.
JUS500IB_JUS500IBCA_ManualENFRSP_040518.indd 8-9
nozzle connector.
®
8
Problem
Solution
Unit fails to Jump-Start
• Make sure unit's power switch is in the ON position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
• Leave charger plugged in and keep unit on charge for 24-48 hours.
Portable Compressor will not inflate
• Make sure the Compressor Power Switch is in the on position.
• Check that jump-starter has a full charge. Recharge unit if necessary.
• Make sure the SureFit
the valve stem when attempting to inflate tires; or that the nozzle
adapter is securely screwed into the SureFit
inserted properly into the item to be inflated on all other inflatables.
• The compressor may be overheated. Press the compressor power
switch to turn the compressor off. Restart after a cooling down
period of approximately 30 minutes.
USB Power Port will not power
• Make sure the USB Charging Port Power Button is in the ON position.
appliance
• Make sure the appliance being powered does not draw more than
500mA.
• Some USB-powered household electronics will not operate with this
USB Power Port. Check the manual of the corresponding electronic
device to confirm that it can be used with this type of USB power port.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
LED Area Light does not come on
• Make sure the LED Area Light ON/OFF button is in the ON position
• Check that Jump-Starter has a full charge. Recharge unit if necessary.

CARE AND MAINTENANCE

All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit
is not in use, we recommend that the battery is charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the unit with a soft cloth
moistened with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires.
Contact manufacturer to replace any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number of factors
including but not limited to the number of recharge cycles, and proper care and maintenance of the
battery by the end user. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be
disposed of properly. Recycling is required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
ACCESSORIES
Recommended accessories for use with this unit may be available from the manufacturer. If you need assistance
regarding accessories, please contact manufacturer at 1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
nozzle connector is securely screwed on to
®
nozzle connector and is
®
9
4/5/2018 10:03:02 AM
Tabla de contenido
loading

Este manual también es adecuado para:

Jus500ibca

Tabla de contenido