Connecting To Power; Radio Operation; Power Supply - Roadstar CDR-4208MP Manual De Instrucciones

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
Caution
To prevent electric shock disconnect from the mains before removing cover. No user
serviceable parts inside. Refer servicing to qualified service personnel.
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: AC230Volts / 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not
required.

POWER SUPPLY

• Remove the stereo carefully from the box, retaining the packaging for future use.
• Please read this instruction book carefully before operating this unit.
AC Power Operation
• Plug the supplied AC power cord into the AC power socket on the back of this portable
stereo. Connect the AC Power Cord to your AC household mains outlet and switch on
the mains supply. Make sure the voltage is compatible.
Battery Operation
• Remove mains lead from the unit for battery operation.
• Open the Battery Compartment (12) at the back of the stereo and insert 6 UM-2 batteries
following the polarity diagram shown inside the battery compartment.
• Batteries should be removed form the compartment if the unit is not to be used for
some time.
• Flat batteries should be removed from the unit to avoid leakage.
English
3
English
4

RADIO OPERATION

Set the Function Selector (4) to the TUNER position ("Tun" appear on the display).
1.
Select the desired frequency band (AM or FM) with the Band Selector (17) Button.
2.
3. Tune to the desired radio station by turning the Tuning control (19).
Press and adjust the Volume +/- (11) control to the desired level.
4.
To turn off the radio, predd the ON/OFF button (16) to the OFF position.
5.
Antenna
For FM reception there is a built-in wired FM antenna (7) at the rear of the unit. Extend the
antenna and move it around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite antenna. Your may have
to orient the unit to obtain the best reception.
VERY IMPORTANT: This unit has a built-in circuit to switch OFF automatichally
the unit after 10 minutes that NO Audio is played from CD or Radio.
COMPACT DISC OPERATION
• To remove a disc from its storage case, press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
• Fingerprints and dust should be carefully wiped off the disc's recorded surface with a
soft cloth. Unlike conventional records, compact discs have no grooves to collect dust
and microscopic debris so gently wiping with a soft cloth should remove most particles.
Wipe in a straight line from the inside to the outside of the disc. Small dust particles and
light stains will have absolutely no effect on reproduction quality.
• Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to