Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FILTER MAINTENANCE
1)
WARNING! Make sure the power is turned off before performing any maintenance. Turn off heater, by using
the main power switch on the rear of the unit and unplug the heater from the wall outlet.
2)
Remove the filter bracket from the rear of the heater.
3)
Remove the filter from the bracket.
4)
Vacuuming will generally clean the filter in most cases.
5)
If dirt remains, rinse filter with warm tap water through the rear side of the filter (opposite of air intake
direction) until clear of dust and debris.
6)
If the filter is extremely dirty or clogged with grease, you can soak the filter in a mild solution of dish soap and
water, and repeat rinsing process.
7)
Shake filter to remove excess water and lay on clean cloth or paper towels to dry. Do not use heat source to
dry filter.
8)
Replace filter in heater ONLY after it is completely dry.
TROUBLE SHOOTING
PROBLEM
1. Heater does not blow warm air
2. No Power to heater
\
PORTABLE ELECTRIC HEATER WARRANTY
All manuals and user guides at all-guides.com
a. The room temperature is higher than the thermostat setting.
b. Check to be sure unit is on high setting.
c. If the power button on the front of the heater is red but the heater is
not operating the safety overheat function may have been triggered. Try
pressing the power button. If the heater does not turn on, clear any
obstructions from front and rear of unit that may have caused internal
overheating. Allow the heater to cool for approximately 10 minutes and
then press the power button again.
a. Make sure main switch on rear of unit is switched to on position.
b. Over heat safety control activated. Remove blockage from filter and
around heater. Unplug heater for 10 to 20 minutes. Unit should then
operate normally.
c. Check circuit breaker, reset as needed or plug into different outlet.
d. Call customer service at 1-814-643-1775 or visit us at
www.worldmkting.com
10
CORRECTIVE ACTION
Tabla de contenido
