Installing The Hood - De Dietrich DHD1103 X Manual De Utilización

Ocultar thumbs Ver también para DHD1103 X:
Idiomas disponibles
  • ES

Idiomas disponibles

2/ INSTALLING THE HOOD

For the correct operation of the Downdraft, it is important for it to be installed correctly.
1)
Drill a rectangular hole to the 790x104 dimension in the rear side of the cook top (fig. 1 ).
2)
If a gas hob is utilised, the minimum distance from the rear edge of the cooking hob to
the downdraft must be at least 50 mm.
3)
Before making the opening, check the inside of the cabinet level with the hood area to
make sure there is no framework or other elements that could adversely affect the correct
installation.
Make sure that the size of the hood with its motor and the work top are compatible with
the unit so as to allow installation.
4)
The motor is delivered fixed to the appliance to prevent any damage during transport. It
is necessary to remove the motor prior to beginning the installation.
5)
Apply some glue on the trim of the lower side of the cooker hood (fig. 2).
6)
insert the downdraft inside the cabinet, from the top, without removing the protections
from the glass or the panel.
7)
The cornice of the hood must adhere perfectly to the upper kitchen top.
8)
Fix the hood inside the furniture utilising the two supplied brackets (fig. 3).
9)
Install the motor on the cooker hood body, orienting the air outlet towards the desired
direction, downwards or upwards (fig. 4).
10) The motor can be fitted in the front or rear part of the hood.
To install the motor in the rear part, proceed as follows: unscrew the plate situated in the
rear part of the hood, screw the motor to the hood in place of the plate, correctly connect
the motor cable and screw the plate back onto the front part of the hood. Attach the air
extractor tube (not supplied). Connect the other end of the tube to the outside of the
furniture for a filter (fig. 5) installation or to the outside of the habitation for an extractor
installation.
Warning: do not make any other holes in the appliance, as this could damage the internal
sliding parts as well as the electrical parts.
11) Position the metal box with the electrical parts in an area that can be accessed easily for
assistance interventions and connect the electric connectors to the hood.
12) Connect the appliance to the mains electricity.
13) Once the installation has been completed and the hood has been connected to the elec-
trical mains circuit, start the extraction of the carriage (refer to the chapter about how the
hood functions) and remove all protective material (Fig. 6 and Fig. 7). Successively open
the door (Fig. 8) and remove the protective material.
Remove the protective PVC from the anti-grease filters and position them as shown in
Fig. 9.
UTILISATION
This product is intended to extract fumes, fats, and steam from cooking. It has been designed
and made for use either in the suction or filter versions.
The air extractor tubes are not supplied as standard.
Version with exterior evacuation
The hood is equipped with an air outlet to convey smoke outwards (the flue pipe and fixing
flange are not supplied).
All manuals and user guides at all-guides.com
17
EN
loading