Lincoln Electric POWER MIG 210 MP Manual Del Operador página 12

POWER MIG ® 210 MP
CASE BACK
FIGURE A.2
3
CASE REAR COMPONENTS DESCRIPTION
1. Thermal Breaker – The Power MIG 210 MP features a resettable
25 amp thermal breaker. If the current conducted through the
breaker exceeds 25 amps for an extended period of time, the
breaker will open and require manual reset.
2. Gas Solenoid Connector – Connection for the gas hose.
3. Input Power Connector – The NEMA input power receptacle
accepts either of the input power cords. To connect, align tabs and
insert. Twist connector clockwise to lock into place.
All manuals and user guides at all-guides.com
INTERNAL CONTROLS
FIGURE A.3
2
INTERNAL CONTROLS DESCRIPTION
1. Spool Gun Switch – Permits toggling between standard push gun
1
2. Wire Drive Tension Pressure Adjustment – Permits increasing or
3. Wire Drive Spindle – Supports a 4-inch or 8-inch spool of wire.
4. Replaceable Wire Guide – Select the correct inner wire guide for
5. Replaceable drive roll – Select the correct drive roll for the wire
6. Optional Foot Pedal Adapter Kit for TIG Welding – The optional
7. Gun Connector Block – Permits securing a welding gun to the
12
2
1
7 6
5 4
welding with the Magnum Pro 175L or aluminum welding with the
Magnum Pro 100SG Spool Gun.
decreasing the pressure applied to the top drive roll.
The center wing-nut can be adjusted to increase tension on the
wire.
the desired wire diameter. The outer wire guide provided can be
used for any wire diameter.
diameter and composition being fed.
K4104-1 Adapter Kit can be installed by removing the plastic plug
button and securing the circular connector to the center panel. The
adapter permits connecting a foot pedal. Use a small flathead
screwdriver to remove the plug button.
wire drive by ensuring the gun connector is fully seated, then
tightening the large knob
DESIGN
3