Dmx-512 Connection - Beamz professional MHL510 Manual De Instrucciones

14 LED 3
15 LED 4
16 LED 5
17 Reset

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX
input of the first unit in a DMX chain. If you wish to connect a DMX controller with other XLR outputs you will need
to use adapter cables.
Connect the DMX output of the first unit in a DMX chain with the DMX
input of the next unit in the chain. Always connect the output of one unit
with the input of the next unit until all units are connected. If you use a
controller with 5 pin DMX connection you will need to use a 5 pin to 3 pin
adapter.
Caution at the unit, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm resistor
between signal (-) and signal (+) into a 3-pin XLR connector and plug this into the DMX output of the
last unit in the chain.
122-151 Red + Green
152-181 Red + Blue
182-211 Green + Blue
212-241 Red + Green
242-255 Red + Green + Blue White
002-031 Red
032-061 Green
062-091 Blue
092-121 White
122-151 Red + Green
152-181 Red + Blue
182-211 Green + Blue
212-241 Red + Green
242-255 Red + Green + Blue White
002-031 Red
032-061 Green
062-091 Blue
092-121 White
122-151 Red + Green
152-181 Red + Blue
182-211 Green + Blue
212-241 Red + Green
242-255 Red + Green + Blue White
002-031 Red
032-061 Green
062-091 Blue
092-121 White
122-151 Red + Green
152-181 Red + Blue
182-211 Green + Blue
212-241 Red + Green
242-255 Red + Green + Blue White
000-254 not applicable
255 Reset after 2 second intervals
11