Idiomas disponibles
Idiomas disponibles
Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut
over the hose and threaded base and tighten
the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 3 bars
Operating pressure:
Recommended operating pressure:1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any problems
or there is not enough flow of water, the waterdimmer
(8a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
English
7 l/min 3 bars
max. 10 bars
16 bars
max. 80° C
65° C
Spare parts (see page 5)
1
handle
1.1 screw cover
2
flange
3
nut
4
service set
5
packing kit (5)
6
mixer ball
7
cartridge cpl.
8
aerator cpl. (10)
9
pop up rod
10
fixing set
11
connection hose
XXX = Colors
520 topaz
530 translucent blue
Special accessories
X
special tool set
(not part of delivery)
34091XXX
94075000
94130000
94106000
13952000
13962000
13964000
14095000
13085000
92620000
13961000
94076000
58085000
7
