MADER LJ1500-24 Manual Del Usuario página 28

▲DANGER!
Improper use of
grounding plug can result
in a possible risk of
electrical shock!
▲DANGER!
adapter with this product!
2. If repair or replacement of cord or plug is
necessary, do not connect grounding wire to either
flat blade terminal. The wire with insulation
having an external surface that is green (with or
without yellow stripes) is the grounding wire.
▲WARNING!
(or green and yellow) wire to a live terminal.
3. Check with a qualified electrician or
serviceman if grounding instructions air not
completely understood, or if in doubt as to
whether product is properly grounded. Do not
modify plug provided; if it will not fit outlet, have
proper outlet installed by a qualified electrician.
▲WARNING!
1. Local electrical wiring codes differ from area
to area. Source wiring, plug and protector must be
rated for at least the amperage and voltage
indicated on motor nameplate, and meet all
electrical codes for this minimum,
2. Use a slow blow fuse or a circuit breaker.
OPERATION
Pressure Switch-Auto/Off Switch-In the
AUTO position, the compressor shuts off
automatically when tank pressure reaches the
maximum pre-set pressure. In the OFF position,
the compressor will not operate. This switch
Do not use a grounding
Never connect green
should be in the OFF position when connecting or
disconnecting the power cord from the electrical
outlet or when changing air tools.
Regulator-The regulator controls the amount
of air pressure released at the hose outlet.
Safety Valve-This valve automatically releases
air if the tank pressure exceeds the pre-set
maximum.
Discharge Tube-This tube carries compressed
air from the pump to the check valve. This tube
becomes very hot during use. To avoid the risk of
severe burns, never touch the discharge tube.
Check Valve-A one-way valve that allows air
to enter the tank, but prevents air in the tank from
flowing back into the compressor pump.
Handle-Designed to move the compressor.
▲WARNING!
on wheeled units to lift the unit completely off
the ground.
Drain Petcock-This valve is located on the
bottom of the tank. Use this valve to drain
moisture from the tank daily to reduce the risk of
corrosion.
Reduce tank pressure below 10 psi, and then drain
moisture from tank daily to avoid tank corrosion.
Drain moisture from tank by opening the drain
petcock located underneath the tank.
LUBRICATION
This is an oil less product and DOES NOT require
lubrication to operate.
BREAK-IN PROCEDUR
▲CAUTION!
or other tool to open end of hose until start-up
has been completed and unit checks ok.
IMPORTANT: Do not operate compressor
before reading instructions or damage may result.
1. Turn regulator fully clockwise to open
airflow.
2. Turn switch to OFF position and plug in
power cord.
3. Turn switch to AUTO position and run unit
4
Never use the handle
Do not attach air chuck