Nolan N90 Seguridad E Instrucciones página 14

Scratched visors and inner visors may cause reduced visibility and must therefore be
changed.
Regularly check the correct air draught of the inner visor to prevent the same from moving and
scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both for sys-
tem correct assembly and air draught.
An excessive and early air draught of the inner visor may result in excessive adherence
against visor surface and/or permanent deformations with subsequent inability to perform fol-
lowing adjustments correctly.
The extended use under special weather conditions may reduce system performance and
result in partial fogging and problems of condensation on the inner visor. In this case, remove
the inner visor from the helmet visor and dry it with dry and lukewarm air.
Intense sweating /breathing, the use under particular weather conditions (low temperatures,
and/or high humidity and/or sudden changes in temperature or heavy rain) and intense and
prolonged use may affect the performance of the system and cause the fogging or formation
of condensation on the inner visor.
In this case, remove the inner visor from the helmet visor and dry it with dry and lukewarm air.
The same procedure must be applied to the helmet, in order to dry out humidity in case it has
formed up as a consequence of the conditions described above.
2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor and release the inner visor from the pins (Fig. 7).
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a wet and soft cloth, polish delicately
with neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a ven-
tilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
• VISION PROTECTION SYSTEM (VPS)
The new and exclusive inner Vision Protection System (VPS) is a scratch-resistant coat-
ed, moulded,
respectively activate it or remove it from the field of vision. It is useful in all sorts of situ-
ations, both on long journeys out of town and shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble the sun-
screen without the need for any tools for ordinary maintenance and cleaning operations.
VPS operation
The VPS mechanism allows activating the sunscreen by simply lowering it until it partially cov-
ers the visor field of vision. In this way, the desired light transmittance reduction is achieved.
At any time, independent of the visor, the VPS can be deactivated with a simple movement
and easily pulled up to restore the normal conditions of visibility and protection guaranteed by
the approved helmet visor.
To activate the VPS, push the slider forward (Fig. 9A) until you hear the click, which means
the slider and VPS are correctly in place.
®
sunscreen. Its use is simple and practical: Just pull it down or up to
14