Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Figure 1
4
2
5
Figure 2
Figure 3
PAGE 3 OF 15
ASSEMBLY
Top
1
5
6
NOTE: Do not tighten bolts until unit is
completely assembled.
VERTICAL ASSEMBLY
1. Locate and separate the left and right sides.
Identify the top of each panel. The top of each
panel has three holes instead of one.
2. Place back (1) on a protected flat surface so that
the flanges face upward. (See Figure 1)
3. Bolt left side (2) to the back so that the side flange
fits around back using 7 bolts and nuts—nuts to
the inside. Do not use bottom 2 holes; these will be
used for attaching legs in step 7. (See Figure 1)
4. Bolt top (5) and bottom (5) to back (1) and left side
panels (2) using 4 bolts and nuts each. Bolt shelves
(4) to left and back side panels using 3 bolts and
nuts each. (See Figure 2)
5. Bolt right side (6) to back (1) so the side flange
fits around back. Attach side to top, bottom and
shelves. (See Figure 3)
1120 IH-2489
Tabla de contenido
