Timer Setting - Franke FHI 754 4I ST CTX Manual De Instrucciones

Alarm timer function
28
display blinking, while the ones of the other zones light on steady.
Operation time can be set for each hotplate separately.
Changing preset cooking time
• Cooking time can be changed anytime during the operation.
• Touch timer's sensor ON/OFF(D).
• By sliding the finger on the cursor (E) of the chosen cooking zone, the time is
changed in intervals of 1 minute.
• Removing the finger from the cursor, the cooking zone works according to the
new set cooking time.
Checking remaining cooking time
• The shorter remaining time is always shown on the timer's display and the
corresponding zone is recognized by the led blinking. Or the shorter time is of the
alarm and no led blinks.
To see the remaining time of the other zones at which the timer is set:
• Press the sensor (D)
• Press (only once) any point of the cursor (E) of the cooking zone of which you
want to know the remaining time.
• The remaining time of the selected zone will be shown on the timer's display.
Turning timer off
When preset time elapses, a beep signals the end, and the hotplate is switched off.
The acustic segnal can be turned off by pressing any sensor or it turns off
automatically after 2 minutes.
If you want to switch off the timer prior the end of preset time:
• Touch timer's sensor ON/OFF(D).
• By pressing the extreme lower position of the cursor for 2 seconds, the set time
will be deactivated. The set time can be also deactivated in intervals of 1 minute,
sliding on the whole field of the cursor.
• The led near timer's display turns off and the timer is deactivated.
The timer has three positions:
• If you press it one time, it's possible setting time or to see the remaining time of
any zone (doing the instructions above)
• If you press it 2 times, it's possible setting alarm (doing the instructions reported
in the alarm's chapter)
• If you press it 3 times, the shorter remaining time is shown.
Timer can be used as alarm also if it is already employed in timer control of one of
the hotplates.

Timer setting

With the hob off:
• Touch the sensor (A) to activate the cooking hob.
• By pressing timer's sensor ON/OFF (D) 2 times, you activate the alarm.
• By sliding the finger on the cursor (E) of any cooking zone, you set the wanted
time.
The alarm's remaining time is shown even though you turn off the cooktop.
Switching the alarm off
After the set time the acustic signal turns on in intervals, and can be turned off by