Features And Controls - Briggs & Stratton 030761 Manual Del Usuario

Compare the illustrations with your generator to familiarize yourself with the locations of various
controls and product warnings.
Carbon Monoxide
QPT
(CO) Shutdown
Switch
Indicator Light
Low Oil Overload
Power Use
Indicator Reset
LED's
120/240 Volt AC, 30 Amp
Locking Receptacle
120 Volt AC, 20 Amp, GFCI Duplex Receptacles — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle — Used to
supply 120 / 240 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
Carbon Monoxide (CO) Shutdown Indicator Light —
Indicates the engine shutdown due to carbon monoxide
accumulation around the generator or a CO shutdown
system fault occurred.
Low Oil Indicator — This unit is equipped with a low oil
protection device. Oil must be at proper level for engine
to run. If the engine oil drops below a preset level, an oil
switch will stop the engine. Check oil level with dipstick.
120 Volt AC, 20 Amp
GFCI Duplex Receptacles
USB Ports
Main Breaker

Features and Controls

Overload Reset — If the generator was overloaded, press
the OVERLOAD RESET button to continue in normal
operating mode. The button also activates the hour meter.
See Hour Meter.
Power Use LED's — Measures the output wattage
(generator load) of all the generator receptacles and
displays the percentage of total generator load. LED's will
also flash to show generator hours. See Hour Meter.
QPT (Quiet Power Technology) Switch — Use this switch
to turn the QPT switch on (I) and off (0).
Rocker Switch Circuit Breaker — The receptacles are
provided with a 2 pole rocker switch circuit breaker to
protect the generator against electrical overload.
USB Ports — Use ports to recharge most USB powered devices.
EN5