Fuel System - Briggs & Stratton 7800950-00 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

How To Store The Battery
If the unit is to be stored out of season, it is recommended
the battery be removed, charged and stored.
1. Remove the battery. Refer to "How To Remove The
Battery".
2. Charge the battery. Refer to "How To Charge The
Battery".
3. Store the battery in an area away from the unit on a
wood surface. DO NOT STORE THE BATTERY ON A
CONCRETE SURFACE.
Storage
1. Thoroughly clean the unit by removing all grass
clippings and debris.
2. Perform maintenance and lubrication as required.
3. Drain the fuel from the fuel tank (unless using a fuel
stabilizer - Refer to "Fuel System").
4. Start the engine and allow it to run until the engine runs
out of fuel. This allows the carburetor and fuel system to
remain clean during storage.
5. Remove and store the battery. Refer to "How To Store
The Battery".

Fuel System

Fuel can become stale when stored over 30 days. Stale fuel
causes acid and gum deposits to form in the fuel system
or on essential carburetor parts. To keep fuel fresh, use
Briggs & Stratton Advanced Formula Fuel Treatment
& Stabilizer, available wherever Briggs & Stratton genuine
service parts are sold.
There is no need to drain gasoline from the engine if a fuel
stabilizer is added according to instructions. Run the engine
for two (2) minutes to circulate the stabilizer throughout the
fuel system before storage.
If gasoline in the engine has not been treated with a fuel
stabilizer, it must be drained into an approved container.
Run the engine until it stops from lack of fuel. The use of a
fuel stabilizer in the storage container is recommended to
maintain freshness.
Engine Adjustments And Repairs
Engine adjustments and/or repairs should be performed by
an authorized dealer.
Rider Adjustments And Repairs
The following adjustment and repair items can be made by
the owner. However, it is recommended that they be made
by an authorized dealer.
22
How To Inspect The Mower Blade
WARNING
Wear heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp and
can cause severe injury. DO NOT use a cutting blade that
shows signs of excessive wear or damage.
Inspect the blade frequently for signs of excessive wear or
damage (Figure 27):
(A) New blade;
(B) Wear limit (notch starts);
(C) Dangerous condition - do not use on mower! Replace
with new blade. Contact your authorized dealer.
Figure 27
How To Sharpen The Mower Blade
Contact an authorized dealerfor assistance regarding
mower blade sharpening.
How To Adjust The Mower Blade
Contact an authorized dealerfor assistance.
How To Level The Mower Deck
WARNING
Wear heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp and
can cause severe injury.
A
B
C
Tabla de contenido

Solución de problemas

loading

Tabla de contenido