Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A
B
Glide x 8
Metal Handle x 5 Sets
1.
Insert glides (A) into bottom of pedestals.
(See Figure 23)
Figure 23
A
2. Turn upright. Remove pre-attached metal handle (B)
from inside of cabinet drawer by unscrewing with a
Phillips screwdriver. Move to the outside of drawer
and re-attach using same screws and a Phillips
screwdriver. (See Figure 24)
D
C
Figure 24
PAGE 8 OF 29
PEDESTAL ASSEMBLY PARTS
C
File Clip x 6
PEDESTAL ASSEMBLY
Tighten
Tighten
B
C
B
D
E
Aluminum Bar x 3
Key x 2 Sets
3. Attach file clips (C) to sides of drawers and insert
aluminum bars (D). (See Figure 24)
4. Remove top drawer by pressing down on plastic
tabs on drawer slides and pulling out.
(See Figure 25)
Figure 25
5. Align pedestals to pre-drilled holes located on
underside of desk top. To attach pedestal to desk
top, insert M6 x 40 mm screws (F) from underside of
pedestal. For extra stability, use #4.5 x 1⁄" screws
(G) to attach pedestal to desk side panel.
(See Figure 26)
Figure 26
6. Replace top drawer by reconnecting drawer slides
and pushing in.
F
Screw x 8
M6 x 40 mm
Tab
F
G
Screw x 8
#4.5 x 1⁄"
F
0921 IH-5679
Tabla de contenido
