Epson EHDMC10 Manual Del Usuario página 27

Troubleshooting
Cannot send or receive images
• Check that the micro USB cable is connected correctly.
• Check that the AC adapter is connected to the electrical outlet correctly.
• Check that the devices are connected to the HDMI Input or the HDMI Output
correctly.
• Check that the input source of the device connected to the HDMI Output is
switched to HDMI.
• Check that you have selected the Sink or Source settings correctly for this
unit and the MOVERIO BT-200.
• Check that the connected device supports HDCP. Devices that do not sup-
port HDCP may not display images.
• If 15 minutes has passed without any signal input during connection standby
status, the connection standby status is cancelled. Press the Wireless/Pass-
Thru button to connect again.
• You cannot send and receive images at the same time. Select Source or Sink
with the slide switch.
• If the Wireless Ready and Link indicators flash alternately, a connection error
has occurred. Press the Wireless Connect button to connect again or press
the Reset button to restart the unit.
• You cannot connect to this unit and your access point using Wi-Fi at the
same time.
• Check that the Wi-Fi direct setting on the MOVERIO BT-200 is on. Note that
even if the Wi-Fi setting is on, communication is not possible if the Wi-Fi di-
rect setting is off.
The image is blurred
• When using communication devices such as Wi-Fi or Bluetooth near this unit,
images are distorted by wireless interference. Move the communication de-
vice away from this unit.
29