Technical Data - Proxxon Thermocut 650 Manual De Instrucciones

3 Technical data

Primary voltage:
Frequency:
Secondary voltage:
Power
Cutting wire temperature: Controllable from
Heating-up time:
Cutting wire thickness
Conducting state length:
Conducting state depth:
This label points to the fact that
this product is not to be disposed
of together with other domestic
refuse throughout the entire EU.
To avoid any detrimental effects on
the environment or adverse ones
on health from an uncontrolled disposal of was-
te, you should recycle responsibly for furthering
the sustained recycling of material resources.
To return your used device, please make use
of the return & collecting system or contact the
dealer from whom you bought the product. You
can supply this product to the environmentally-
compatible recycling scheme.
4 Key Fig. 1
1. Temperature regulating knob
2. On-off switch
3. Supply lead
4. Pulley with cutting wire
5. Wire holder
6. Clamping for cutting wire
7. Cutting wire
8. Moveable wire holder
9. Locking screw for telescope
10. Retaining bracket
11. Rubber nubs
12. Screw clamp
13. Housing
230 V ~
50/60 Hz
40 V max.
50 W
100 – 350 °C.
1 sec.
0.2 mm
400-650 mm
200 mm
Please note!
• The cutting wire can heat to 350 °C when in
operation. Do not touch! Risk of burns!
• Ensure that no electrical leads or objects
come unintentionally into contact with the
hot cutting wire!
• Always pull out the mains plug after use!
• Keep children away from the working area!
5 Placing Thermocut 650 into
operation
Danger!
The mains plug must not be plugged in during
the work described here. This is to ensure that
the device is not unintentionally switched on.
Injuries from the hot cutting wire could result
otherwise.
Clamping the cutting wire
1. Loosen knurled screws of the clamping Pos.
6, insert wire into the clamping and fi rmly
re-tighten the screws.
Setting the cutting length of the Thermocut 650
This is done by adjusting the outer telescopic
bracket and the corresponding variation of the
cutting wire length. It is recommended keeping
this preferably short - in keeping with the task
- to minimize the deformation caused by the
wire's fl exibility during the work.
1. Loosen clamping screw Pos. 9.
2. The wire holder can now be both retracted
and extracted
3. Undertake the setting required. Please note:
Make sure that the moveable wire holder
is in a vertical position! This ensures an
optimum compromise between spring pre-
tension and spring pitch!
4. Fix by tightening clamping screw Pos. 9.
Please Note!
Make sure that the moveable wire holder is at
right angles to retaining bracket 9! This ensures
- 9 -