Troubleshooting - Mosquito Sentry GS-1018 Manual De Instrucciones

TIPS FOR PROPER USE OF YOUR MOSQUITO SENTRY
Never use any material other than 100% natural Mosquito Sentry Repellent in the unit.
This system is designed to reduce the repellent into submicron particles and disperse
them over a wide area. Filling the unit with chemicals, pesticides or other products will
damage the unit and may cause serious injury due to inhalation.
The Mosquito Sentry is designed to protect a 300 square foot area. In windy conditions,
it may be necessary to move the unit closer to your sitting area.

TROUBLESHOOTING

If your Mosquito Sentry is not working correctly, please check the following causes:
TROUBLE
Mosquito Sentry does not
operate.
The power light is on, but
there is no vapor.
The repellent vapor produces
an unpleasant smell.
The power light is on, but the
Mosquito Sentry doesn't work.
The output volume of the
vapor is low, or the unit is
blowing bubbles.
Abnormal noise
7
All manuals and user guides at all-guides.com
PROBABLE CAUSE
Battery needs re-charging or
the reservoir is empty.
No repellent in reservoir
New machine
Dirty reservoir, or the product
is left in the reservoir for too
long.
Too much repellent in the
base
The transducer is dirty.
Repellent mixture may be too
strong (if using concentrate).
Vibrations in reservoir when
level is too low
Unit is on an unstable surface.
SOLUTION
Plug in power cable.
Fill reservoir with repellent.
Open the reservoir and leave
it for 12 hours in a cool, dry
place.
Clean the reservoir and
change the repellent.
Pour out some repellent from
the base.
Run a 50/50 mix of vinegar
and water in the system for
five minutes.
Add 6 oz. of water to the
reservoir.
Fill the reservoir.
Move the unit to a stable, flat
surface.
7