G-Systems FC01-210EU-AC Manual De Instrucciones página 16

Thank you for purchasing a Digital Fan Controller (DFC). DFC is a
speed regulator for ventilated rooms to control exhaust air fans or intake
and exhaust air fans. The function of all fan controllers involves maintaining
a room at constant temperature and at the same time creating a negative
pressure in order to prevent odours escaping.
EN
The warranty is only valid with a warranty card containing sales date
and stamp from the place of purchase. Or electronic registered warranty at
http://g-systems.eu/warranty. If this is not so, please return immediately
to the sales office!
1. Socket 1 (intake fan)
2. Power ON LED
3. Temperature LED
4. Humidity LED
5. Regulation knobs
6. Socket 2 (exhaust fan)
7. EC output (optional)
8. Wall mounting bracket
9. Cable gland 12 mm (sensor)
10. Cable gland 16 mm (power cable)
Mount the fan controller to a wall to obtain the best cooling
performance. Make sure the mounting surface is heat and fire resistence,
for example concrete or brick wall, don't mount the fan controller to a
woodern or any other burn able surface. Make sure there is enough space
and a good air circulation arround the controller minimum 20cm from all
sides. The maximum working temperature is 80 degree celsius!
Swing out the four mounting brackets on the backside of the controller,
put the screws through the existing hole.
Insert the exhaust air fan into the right socket, marked as exhaust fan
and depending on the controller, an intake fan into the left socket, marked
with intake fan. Install the temperature sensor or humidity and temperature
sensor which is provided with a 4 m long cable at a point where you wish to
undertake the measurement.
14
Digital fan controllers
Foreword
Warranty
Legend
Mounting installation
Instructions