Axial Piston Pump With Load-Sensing Pump Controller - Festo 8065075 Manual De Usuario

Hydraulic power pack with load sensing variable displacement pump and constant displacement pump
8.3

Axial piston pump with load-sensing pump controller

1 Drive shaft, 2/8/9/16 Compression springs, 3 Swash plate, 4 Adjustment piston, 5 Venting and filling connection, 6 Piston for
regulating maximum pressure, 7 Piston for regulating pressure rise, 10 Pressure rise adjusting screw, 11 Maximum pressure adjusting
screw, 12 Delivery rate limiter, 13 Pump housing, 14 Drive shaft for gear pump, 15 Valve sub-base, 17 Cylinder block, 18 Piston,
19 Piston shoe
Axial piston pump with load-sensing pump controller and ports LS, P, S, L
Axial piston pump
The cylinder block (17) is set into rotary motion by the drive shaft (1). The pistons (18) in the cylinder block
rotate on the swash plate (3). The pistons are held by the piston shoes (19), which can also pull them out of
the piston block.
If the swash plate (3) is perpendicular to the drive shaft, the pistons rotate without any longitudinal motion.
No hydraulic oil is drawn in or pressed out. This position is designated zero stroke length. If the swash plate
swivels out, angle α becomes larger and the longitudinal motion of the pistons increases. Hydraulic oil is
thus drawn in in the lower area, and pressed out in the upper area. Angle α determines the pump's delivery
rate. The swash plate is adjusted by the adjustment piston (4) in combination with the compression
spring (2).
22
© Festo Didactic 8068243