Assembly; Mounting Grip Rod; Clipping In The Cable Holder; Assemble The Carrying Handle Of The Grass Catcher - Grizzly Tools ERM 1846 GT Traducción Del Manual De Instrucciones Original

• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when
working. The cutting blades
may damage the power cable
and result in contact with live
parts. Always run the power ca-
ble behind the operator.
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do
not touch a damaged power
cable when it is connected to
the mains. A damaged power
cable may result in contact with
live parts.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Mounting grip rod

Fitting the lower bar:
1. Press both ends of the lower
bar (4) together and position
both boreholes in the pins at the
mounting of the device housing
(10).
2. Screw the lower bar tight (4)
with the enclosed short screws
and the star knob nut (6) both
right and left of the mounting of
the device housing (10).
Three positions are possible.
Fitting curved handle:
3. Screw the lower bow-type han-
dle tight (1) with the enclosed
long screws, washers and the
star knob nut (3) both right and
left of the lower bar (4).
Clipping in the cable
holder
Clip the cable holder (15) into the lower
bar (4) and use it to secure the equipment
cable (18).
Assemble the carry-
ing handle of the grass
catcher
1. Loosen the cross-drive screw (14a) on
the carrying handle (14).
2. Place the carrying handle (14) on the
upper side of the grass catcher (7) and
screw it tight with a cross-drive screw
(14a) from below.
Operation
Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
GB
73