Trust ALSET-2000 Guía De Instalación Rápida página 12

ALSET-2000 WIRELESS SECURITY SYSTEM
EN
15. ALSIR placement
When placing the siren on a wall keep attention that the tamper switch isn't placed on a groove or
crack in the wall. Make sure that the tamper switch is placed on a location of the wall where it is firmly
pressed.
Note: More detailed mounting instructions of the siren are available at trust.com/71112
16. Arm/Turn on the siren
To arm the siren press the ON button for 4 seconds on the ALKCT.
If the siren is armed successfully the LED of the ALKCT will light up for 1.5 sec.
17. Walk-out time
When the Siren is armed there is a 85 sec walk-out time. Within these 85 sec the system checks all
the sensors if they are responding and it is possible to leave the building without triggering the alarm.
When there already is a window or door open at the beginning of this walk- out time the alarm will
go off for 20 sec reminding that one of the doors or windows isn't closed. After the window or door
sensor is closed the alarm will stop and continue in armed mode.
18. Disarm/Turn off the siren
To disarm the Siren press the OFF button for 4 seconds on the ALKCT.
If the Siren is disarmed successfully the LED of the ALKCT will light up for 1.5 sec.
19. Mounting the ALKCT holder
Mount the holder of the ALKCT on a flat surface and secure it with screws. (Mounting screws not
included)
20. Place ALKCT in holder
When the holder has been mounted and secured with screws place the ALKCT in the holder. To place
the ALKCT slide it in from top to bottom.
4