Trust ALSET-2000 Guía De Instalación Rápida página 11

ALSET-2000 WIRELESS SECURITY SYSTEM
EN
10. Mount ALMST
Place the magnetic sensor on the window or door and make sure that both points on the two parts
are in line with each other. Mark the top and bottom of both parts. After marking the positions remove
the sensor.
11. Fasten the ALMST
Screw or tape both backplates of the magnetic sensor on the window or door according to the made
markings. When securing the backplates make sure both parts are mounted with as little space
between as possible (max. 5mm). Place both parts of the magnetic sensor back on the mounted
backplates.
Note: More detailed mounting instructions of the magnetic sensor are available at trust.com/71113
12. Mount ALMDT
Mount the backplate of the motion sensor on a flat surface and secure it with screws. (Screws are
included).
13a. Fasten the ALMDT
Place the ALMDT on the backplate untill you hear a click. Make sure that the backplate is fitted in the
location of the tamper switch.
Note: More detailed mounting instructions of the motion sensor are available at trust.com/71114
13b. Secure the ALMDT
When the ALMDT is placed on the backplate pull it down untill you hear a click to secure it and lock the
tamper switch.
Note: After arming the Siren it is possible to move in front of the sensor for 1 min. It takes ~1.5 minute
before the sensor will be completely active.
14. Mount ALSIR
To fasten the siren slide the cap off (see step 2) remove the batteries and screw the casing with
screws on a flat surface according to the screwholes. (Screws are included). Keep attention that the
tamper switch is pressed to the surface after mounting the siren.
3