Cleaning And Maintenance - Eldom coffea MK150 Manual De Instrucciones

Ocultar thumbs

Contenido

página de 41

/ 41
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

COARSE,

MIDDLE

FINE

Twist the container until the desired grade corresponds to the index on the housing (5);

- Grind fineness should be always adjusted before you put coffee beans in the device;

- Put coffee beans in the container. The amount of coffee beans must not exceed the MAX

index;

- Mount the cover (1);

- Plug the device to the grid with parameters as mentioned in this manual;

- Press the ON/OFF button (4) to grind the beans. Do not use the device for more than

60 seconds to prevent its engine from overheating. Wait at least 1 minute before using

the device again. The total operation time must not exceed 2 cycles, each lasting 60s.

Following the two cycles, let the engine cool off for a long enough period, i.e. about 10

minutes;

- After the coffee has been ground, wait until the abrasive surfaces come to a halt and

then remove the container (6) and open the cover (7). The device is fitted with two

safety features preventing the device from starting if the containers (2) and (6) are

not mounted properly. Please adhere to the continuous working time of the device.

Exceeding the working time or the lack of required working pauses might irreversibly

damage the engine. A thermal safety feature will be activated in the case the engine

starts to overheat and the grinder will turn off automatically. In that case, you can turn

on the device only after the engine has cooled off. Do not put your fingers or any objects

in the container (2).

USEFUL TIPS

- It is recommended to grind an exact amount of coffee needed at any given moment;

- If you prepare the grind for an espresso machine, please follow recommendations from

the manufacturer of the espresso machine;

- You can store the unused grind in the container (6). You can close the hole (9) on the

cover (7) by turning the knob (8) counter-clockwise;

- Before using the device, please make sure that the hole (9) on the cover (7) is open;

otherwise, the device will work improperly;

- Fineness of the grind should be adjusted before you put the beans in the machine. If you

want to readjust the fineness after the beans have been put in the device, you can do it

only while the engine is operating. In the event that the abrasive surfaces of the machine

get blocked, unplug the burr grinder, empty the container (2), unscrew it and clean the

abrasive surfaces (see: CLEANING AND MAINTENANCE).