Environmental Protection - PALSON City Modo De Empleo

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Hose storage:

For your comfort, the vacuum cleaner has a groove on its side to put the floor accessory and hose into

when you are going to move or put it away (Fig. 6).

ACCESSORIES

1. The accessories can be directly inserted on the handle removing the telescopic tubes and inserting

the required accessory.

2. The accessories can also be fitted to the telescopic metal tube for reaching greater distances.

Remove the head for combination of floors and insert the required accessory.

Accessory for grilles (10): for grilles, corners, grooves, etc.

Accessory for upholstery (1): for carpets, upholstery, stairs, etc+.

DUST CONTAINER AND FILTERS

Removal and replacement:

Cleaning the filters whenever the dust container is emptied is recommended for the machine to

operate at optimum capacity.

Always unplug the vacuum cleaner from the socket before removing the dust container.

Do not use the vacuum cleaner without all of its filters installed.

Emptying the dust container:

1. Press the container release button (14) and lift up the dust container (Fig. 7).

2. Hold the container over a rubbish bin and press the container opening button (15) as indicated to

empty the container. When all of the dust has been emptied, close the container's lid, until you hear

a click. Then put the dust container back in (Fig. 8).

Filter cleaning:

1. Turn the dust container around and remove it (Fig. 9). Remove the first filter, turn the multicyclonic

filter 90 º clockwise, and then pull it out.

2. The multicyclonic filter should be cleaned with a soft brush. Then clean it with a damp cloth. The

dust container can be rubbed until clean (Fig. 10).

3. Leave the filters to dry totally before putting them back in.

IMPORTANT:

The multicyclonic filter should not be put under water.

Do not use detergents or boiling water for washing the filters. Cleaning the filter every time the waste

container is emptied is recommended.

4. Put the container back in as indicated.

Hepa filter cleaning:

This filter is on the back of the vacuum cleaner.

1. Release the Hepa filter lid and remove it as indicated. Remove the filter pulling the flap towards

you (Fig. 12).

2. The filter can be knocked against the side of a rubbish bin to remove excess dirt and dust.

3. The Hepa filter can be washed in lukewarm (max. 40 degrees, Fig. 13). Leave it to dry for 24 hours

before putting it back in.

NOTE:

Do not use detergents or boiling water for cleaning the filters. Washing the filter once every 9-12

months is recommended.

4. When it is totally dry, put the Hepa filter back into the vacuum cleaner. Put the Hepa filter lid back

on before turning the vacuum cleaner on.

STORAGE

Always unplug the vacuum cleaner from the socket and pick up the cable as indicated before putting

the vacuum cleaner away.

TROUBLESHOOTING

To minimise the risk of injuries, unplug the vacuum cleaner before carrying out maintenance/

troubleshooting checks.

PROBLEM

The vacuum cleaner does not

It is not correctly plugged in

work

The socket has no electricity

The on/off (I/O) switch has not

been activated

The motor thermostat has

triggered

Blown fuse/tripped switch

The vacuum cleaner does not

Dust container not correctly

hoover

installed

Dust container full or blocked

Blocked filters

The accessories do not

The accessories have not

hoover

been correctly fitted

The hose is not correctly

installed

Dust comes out of the

The dust container is full

vacuum cleaner

The dust container is not

correctly installed

The filter is not correctly

installed