Installation And Connection; Installing The Cable Conduit Access; Unpacking - Porsche PWCCU192 Serie Manual Del Usuario

Fig. 12 Screw attachment points in the recess for
winding the cable (rear view of the Wall Charger
Connect)
Information
After installation, remove the protective film on the
display and on the decorative front panel.

Installation and connection

Installing the cable conduit access

Unpacking

e
Remove the contents from the package and
check that all parts are present and undamaged.
Electric shock, fire
DANGER
Incorrectly installed connections can cause electric
shock or fire when the high-voltage battery is
charged using the vehicle charge port.
e
Switch off the supply voltage and make sure that
the voltage is off before installation works are
performed.
e
Observe the locally applicable electrical installa-
tion regulations, fire protection measures, acci-
dent prevention regulations and escape routes.
Information
The outer shell is only a cosmetic cover. Do not screw
any cable conduit fittings to it. The Wall Charger
Connect must be opened internally for installation
works.
Information
Ensure when drilling that no shavings fall into the
interior of the Wall Charger Connect.
e
If shavings do fall into the interior, remove these
before continuing with the installation.
1. Lay the supply cable to the place of installation
of the Wall Charger Connect.
2. Install a suitable fuse and use a fire-retardant
cable conduit system.
Installation and connection
Fig. 13 Breakthrough area at top and bottom
3. Use a saw or a sharp knife to make the break-
through for the cable conduit.
17