Installing; Installing The Wall Mount; Wall Installation; Closing The Cover - Porsche PWCCU192 Serie Manual Del Usuario

Installing

Installing

Installing the wall mount

Wall installation

The Wall Charger Connect has four screw connec-
tions in total for installation on the wall.
Fig. 10 Wall fastening openings on the Wall Charger
Connect
The following points must be observed when instal-
ling on a wall:
–
The basic construction of the wall must be
such that it can bear the weight of the fitted
Wall Charger Connect plus an additional 60 lbs
(27 kg).
– Bumps in the wall on which theWall Charger
Connect is to be installed must be smoothed out
before installation.
16
–
The Wall Charger Connect may only be attached
to the wall in a vertical position (see picture
above).
–
The following fastening points must be used
when installing on a wall:
– Solid wall: Use all four fastening points to
make the screw connection.
– Dividing wall/partition wall: Use the centre
fastening points at top and bottom to make
the screw connection.
– Use wall plugs to suit the wall.
– M8 flat screws are to be used for the screw
connection.
–
To insert the screws, the bosses must be drilled
with an 0.3 in. (8 mm) drill bit.
–
Only the screw bosses to be used may be drilled.
–
To seal the screws, use the sealing washers sup-
plied.
–
To mark the drill holes on the wall, use the drill
template supplied.

Closing the cover

Before switching on the Wall Charger Connect, the
cover must be secured using the enclosed screws.
e
Use Torx TX25 screws.
e
Tighten the 13 screws to secure the cover with a
tightening torque of 1.1 ftlb. (1.5 Nm).
Fig. 11 Screw points of the cover
Attaching the decorative front panel
The decorative front panel is secured via four screws.
The screwholes are in the recess for winding the
cable (not visible from the front).
–
Position the decorative front panel on the device
and fix with the four screws (tightening torque
1.1 ftlb. (1.5 Nm)).
To do this, use a Torx TX 25 screwdriver with a
short shaft.