Registering And Identifying Sensors - Dometic MWE 7006 Manual De Instrucciones

MWE7006
8

Registering and identifying sensors

The sensors and their position must be registered by the control unit. To do
this, proceed as follows:
➤ Switch on the ignition.
➤ Engage the reverse gear.
✓ The control unit registers the sensors connected.
✓ The display on the control unit shows LE.
✓ The loudspeaker emits short acoustic signals repeatedly.
Once the registration is complete, LE flashes on the display. The sensors
must now be identified by the control unit.
➤ Park the vehicle so that it is surrounded by at least 1.5 m of free space to
ensure the sensors cannot detect any obstacles.
➤ Switch the ignition off and on again.
➤ Engage the reverse gear.
➤ Press both buttons on the control unit for more than three seconds.
✓ The control unit registers the sensors connected.
Once the registration is complete, the loudspeaker emits a long acoustic
signal. The sensors must now be identified by the control unit.
The display shows a running light and the loudspeaker emits short acoustic
signals repeatedly.
➤ Proceed as follows in accordance with the installation alternative you
selected (fig. 6):
– Alternative A: Use a large object approx. 0.5 m² in size (e.g. a piece of
sturdy paper) and go to sensors 1 to 6 successively (fig. b A)
– Alternatives B and C: Starting at the driver's door, walk around the
vehicle from the first to the last sensor (fig. b B and C).
✓ The loudspeaker acknowledges each sensor detected with a short acous-
tic signal.
Once identification is complete, the loudspeaker emits a long acoustic signal.
EN
Registering and identifying sensors
9