Honda HRX537HYEA El Manual Del Propietario página 16

00X39VH7 Y210.book Page 16 Thursday, May 30, 2013 2:17 PM
5. Loosen the top [3] and
bottom [4] drive clutch cable
locknuts with a 10 mm
wrench. Move the adjuster
[5] up or down, as required,
until the mower operates as
outlined in step 4. Tighten
the locknuts.
Throttle Cable Adjustment
1. Move the throttle lever [1] to the
fast position [2].
2. Remove air cleaner cover.
3. Check that the control
lever [3] just touches the
stopper screw [4]. If
adjustment is required,
proceed to step 5.
[4]
[3]
4. Loosen lock nuts [5] with
a 10 mm wrench. Move
adjuster [6] up or down as
required to achieve
clearance in step 3.
Retighten locknuts [5].
BLADE REMOVAL AND INSTALLATION
If you remove the blades for sharpening or replacement, you will need
a torque wrench for installation. Wear heavy gloves to protect your
hands.
BLADE SHARPENING: To avoid weakening the blades, or causing
imbalance or poor cutting, the blades should be sharpened by trained
staff at an authorized Honda dealer.
BLADE REPLACEMENT: Use Honda Genuine replacement blades or
their equivalent.
16
Blade Removal
1. HYEA: Put the throttle lever in the STOP position.
HZEA: Turn the key to the OFF position.
2. Disconnect the spark plug cap. Tilt the mower to the right so the
fuel cap is up. This will help prevent fuel leakage, motor oil seeping
into the air filter, and hard starting.
[3]
[4]
[5]
[1]
3. Use a 14 mm (6 point) socket wrench and remove the two blade
bolts [1] and special washers [2] from the blade control assembly
[5]. Use a wooden block to prevent the blades from turning when
[1]
removing the bolts.
4. Remove the upper [4] and lower blades [3].
Blade Installation
1. Clean dirt and grass from around the blade mounting area.
2. Install the blades [3] and [4] using the two blade bolts [1] and
special washers [2] as shown.
[7]
[5]
[6]
Be sure to install the special washers with the concave side toward
the blades and the convex side toward the head of the bolt.
The blade bolts are specially designed for this application and
must not be replaced with other bolts.
ENGLISH
[4]
[3]
[2]
[3] [4]
[6]

WARNING
Operating this mower with only one blade will result in an
improperly seated blade that can be thrown from the
mower and seriously hurt or kill someone.
Always use both blades as a set.
[5]
[2]
[1]