Using Individual Lines And Crossed Lines - Parkside PKLL 8 A2 Traducción Del Manual De Instrucciones Original

Note: operation without automatic levelling will always be indi-
cated via the red LED indicator
Note: if the product is agitated or its position is changed during
operation, the product will automatically re-level. After re-levelling
check the positions of the horizontal and vertical laser lines against
reference points to avoid errors.

Using individual lines and crossed lines

When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less
than 4° (green LED on), carefully press the H-button
horizontal line on or off.
Or correspondingly press the V-button
on or off.
Crossed lines can be locked with this product:
When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less than
4° (green LED on) hold down the H-button
tor goes red. Now automatic levelling is switched off and the
2
crossed lines are permanently switched on - even if the base of the
measurement device deviates from the horizontal by more than 4°.
You can turn this mode off again by pressing and holding down the
H-button
1
tomatic levelling system has been switched on again.
The crossed lines are turned off as soon as the base of the measuring
tool deviates from the horizontal by more than 4°, and the LED indica-
tor will turn red again.
2
32 GB/IE
until the LED indicator
.
2
to turn the vertical line
4
until the LED indica-
1
goes green again. The au-
2
to turn the
1