Before Installing Your Dishwasher; Installation Instructions; Levelling; Water Pressure - THOMSON TDW 1445 Manual De Instrucciones

BEFORE INSTALLING YOUR DISHWASHER

Before connecting your dishwasher to the power supply, check that the voltage
stated on the rating label of your appliance corresponds to the voltage in your home.
The appliance must be grounded. The manufacturer is not responsible for damages
that may occur as a result of usage without grounding.

INSTALLATION INSTRUCTIONS

Your dishwasher can be installed in various locations in your kitchen as long as there is
space and accessibility to connect your dishwasher to the water/drainage and electrical
supply.
NOTE: The plug must be accessible at all times.

LEVELLING

Place the dishwasher on an even, stable surface.
It is very important that the dishwasher is perfectly levelled in order to avoid any
malfunction. You can level the dishwasher by adjusting the base feet.

WATER PRESSURE

For best operating results, incoming water pressure should be between 0.04 MPa and
1MPa. Incoming water supply for the dishwasher is controlled by a 'pressure switch', so if
the household water pressure is low, dishwasher fill time will increase or may not operate.
WARNING: Please close the hydrant after using.

CONNECTING YOUR DISHWASHER

Inlet hose (Cold water supply)
The water inlet hose from the machine terminates in a 3/4" female
connector. The water supply should therefore terminate in a similar male
connector and should have a stopcock close by in the pipe.
Connect the straight connector of the inlet hose to the water supply
securely ensuring that the washers are securely in place at both ends
of the hose.
5