Electrical Safety - Black and Decker GL220 Manual De Instrucciones

E N G L I S H
Switch off, remove the plug from the
socket and ensure that moving parts have
stopped rotating before leaving the
appliance unattended and before
changing, cleaning or inspecting any parts
of the appliance.
Before using the appliance, check that your
cutting path is free from sticks, stones,
wire and any other objects.
Only use the appliance in the correct position,
with the cutting line near the ground, as shown
in the illustrations. Never switch the appliance
on in any other position.
Switch on the appliance only when hands and
feet are away from the cutting line.
Avoid body contact with the cutting line while
the appliance is running.
Do not work on steep slopes. Be sure of your
footing. Be aware that freshly cut grass is
damp and slippery.
Take care when trimming near borders and
gravel paths or roads, as stones and soil may
be moved by the cutting line.
Do not put the appliance down until the
cutting line has come to a complete standstill.
Use only the appropriate type of Black & Decker
cutting line. Never use metal cutting line or
fishing line.
Take care to avoid injury from the line
trimming blade. Do not touch the blade.
After extending new cutting line, always return
the appliance to its normal operating position
before switching on.
Take care to keep the mains cable away from
the cutting line. Always be aware of the position
of the cable.

ELECTRICAL SAFETY

The appliance has been designed for one voltage
only. Always check that the power supply
corresponds to the voltage on the rating plate.
This appliance is designed for use on
AC (mains) power supplies only. Do not
attempt to use on any other supply.
8
This appliance is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Prevent body contact with earthed or
grounded surfaces (e.g. metal railings, lamp-
posts etc.).
Electric safety can be further improved by
using a high-sensitivity (30 mA/30 mS) residual
current device (RCD).
Mains plug replacement (U.K. & Ireland only)
Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorised
repair agent or a qualified electrician.
Disconnect the plug from the supply and
remove the fuse from the plug.
Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
Use 5 Amperes fuses.
The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see above). Brown
is for Live (L) (2), blue is for Neutral (N) (4).
Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
If the plug has a fuse cover, make sure that the
fuse cover is fitted. Do not use the plug if the
fuse cover is missing or damaged.