Changing The Filter; Changing The Motor Protection Filter; Transport; Maintenance - Rothenberger RODIA DRY CLEANER 1200 Instrucciones De Uso

 Open the side latches, remove the top section.
 Carefully pull the flange off the suction spigot and close off the flange.
 Dispose of the vacuumed up material in accordance with legal requirements.
Insert fleece filter bag:
Note: Only use fleece filter bags for dry vacuum cleaning.
 Slide the flange completely over the suction aperture.
 Place the upper section on the container and close the side latches.
3.7

Changing the filter

Changing the folding filter:
 Shake the folding filter cassettes before changing them.
 Turn the lock on the latch through 90° in a counter-clockwise direction with a coin or similar
object and push the latch to the rear.
 Fold the hood up.
 Immediately isolate the folding filter cassettes that you have removed in a dust-tight plastic
bag and dispose of properly in accordance with the stipulations.
 Insert new folding filter cassettes.
 Lift the locking bracket up, fold the hood down and click in place with light pressure.
3.8

Changing the motor protection filter

Note: If the motor protection filter is contaminated this indicates defective filter cassettes.
 Replacing the folding filter cassettes.
 Replace the motor protection filter or wash the motor protection filter under flowing water,
dry and re-insert.
3.9

Transport

 The motor head must be securely fixed to the container (close the latches).
 Place the accessories in a suitable plastic bag and seal the plastic bag or place it in the tool
storage compartment.
 Plug the ends of the suction hose into each other.
 Place the hose around the vacuum cleaner and clamp onto the handle.
4

Maintenance

Switch the vacuum cleaner off and pull out the mains plug before any maintenance work!
For maintenance by the user, the vacuum cleaner must be
-- dismantled,
-- cleaned and
-- maintained,
as far as possible without creating any danger to the maintenance personnel or other.
Precautionary measures:
Suitable precautionary measures include
-- Cleaning before dismantling,
-- Provide local filtered positive ventilation where the vacuum cleaner is to be dismantled,
-- Clean the maintenance area and
-- suitable personal protection equipment
20
All manuals and user guides at all-guides.com
Note: Operating the rotary slider:

Push the rotary slider from the inside to the outside, turn through
180° (see mark) and then push inwards again from the outside
through the suction spigot.
 Place the rotary slider in the suction aperture with the mark ▲
pointing upwards.
ENGLISH