Ingersoll Rand 4429 Especificaciones Del Producto página 3

Product Safety Information
Intended Use:
This Air Reciprocating Saw is designed for cutting plastics, fi berglass, composites,
aluminum and sheet metal.
For additional information refer to Air Reciprocating Saw Product Safety Information
Manual Form 16578809.
Manuals can be downloaded from www.ingersollrandproducts.com
Product Specifi cations
Strokes Per
Minute
Model
spm
4429 5,000
429 10,000
529 9,500
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air fi lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off , to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16585382 and table on page 2. Maintenance frequency is shown in a circular
arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1. Air fi lter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
16574873_ed3
Length
Stroke
without
Length
Blade
in (mm) in (mm) † Pressure (L
9.25 (234) 0.39 (10)
8.25 (209) 0.39 (10)
9.67 (245.5) 0.39 (10)
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
P
66.2 77.2
84.3 95.3
84.0 95.0
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
EN
Vibration (m/s 2 )
(ISO28927)
) Level *K
W
9.5 2.4
25.7 4.0
3.1 1.03
EN-1