TFA Dostmann 98.1030 Instrucciones Para El Manejo página 8

TFA_No. 98.1030_Anleit_03_20
Radio-controlled alarm clock
with thermometer
Caution!
Risk of injury!
• Keep this instrument and the batteries out of the
reach of children.
• Batteries contain harmful acids and may be haz-
ardous if swallowed. If a battery is swallowed,
this can lead to serious internal burns and death
within two hours. If you suspect a battery could
have been swallowed or otherwise caught in the
body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-
circuited, taken apart or recharged. Risk of
explosion!
• Low batteries should be changed as soon as
possible to prevent damage caused by leaking.
Never use a combination of old and new batter-
ies together, nor batteries of different types.
• Wear chemical-resistant protective gloves and
safety glasses when handling leaking batteries.
Important information
on product safety!
• Do not place the unit near extreme tempera-
tures, vibration or shock.
• Protect it from moisture.
5. Elements Fig. 1
Part A- LCD
A1: RC reception icon
A2: Radio controlled time
A3: Alarm icon
A4: Month and day display
A5: Temperature display
Part B- Buttons
B1: "SNOOZE/LIGHT" button
B2: "MODE/SET" button
14
12.03.2020 14:19 Uhr
Radio-controlled alarm clock
with thermometer
B3: "+(12/24)" button
B4: "-(C/F)" button
B5: "AL ON/OFF" button
Elements Fig. 2
Part C- Structure
C1: Battery compartment
6. Getting started
• Open the battery compartment and remove the
insulation strip. Close the battery compartment
again. The unit is now ready to use.
Radio-controlled time reception:
• After start-up the clock will scan the DCF time
signal ("
appears permanently when it is received suc-
cessfully. Important: Buttons will not function
while scanning for DCF unless they are well
received or stopped manually.
• The clock automatically scans the time signal at
3.00 a.m. everyday to maintain accurate timing.
For failed reception, scanning stops and repeats
again at 4.00 a.m. 5.00 a.m. and 6.00 a.m.
• The clock manually scans the DCF time signal by
holding
"-(C/F)"- button for 3 seconds. For failed recep-
tion, scanning stops and repeats again the next
4 clock hours. • Press "+(12/24)"- button and "-(C/F)"- button"
again to stop scanning.
• In case the clock cannot detect the DCF-signal
(for example due to disturbances, transmitting
distance, etc.), the time can be set manually. The
clock will then work as a normal quartz clock.
(see "Manual setting of clock and calendar").
Seite 8
" flashes on the LCD). The signal
"+(12/24)"- button and
15