insert the bulb under this retainer clip. Repeat the process on
the opposite side, then push the bulb into the bulb socket (G).
Step 4: Replace the door frame and lens assem-
bly and secure it by tightening the knob
that was loosened in Step 1.
Step 5: Repeat process for second fixture head.
Assembling the fixture
Step 1: Remove the pole and stand assembly
from the box. Loosen the locking knob
located just above the stand assembly
and open the legs to the full open posi-
tion. Secure the locking knob and place
the pole and stand assembly on
a flat surface (H).
Step 2:To mount each light fixture to the light
bar, first loosen and remove wing knobs
from both bolt holes located on the light assembly bar. Place
each bolt through the "U" brackets on the light fixtures, then
through the light assembly bar. When positioned correctly, the
small hole in the center of the light assembly bar should be fac-
ing up. Place the wing knobs in position (under the bar)
and tighten until secure. N OT E : The metal
washer should be placed between the bolt
and " U " b ra cket, and the wave wa s h e r
b e t ween the " U " b ra cket and light bar. T h e
other flat washer should be positioned
b e t ween the light bar and wing knob (I).
Step 3:To attach the light assembly bar to the
adjustable pole, position the hole in the mid-
dle of the light assembly bar over the threaded screw on the
pole. NOTE: The large hole in the light assembly bar should be
facing down to fit over the nut already in place. Once the light
assembly bar is in place, position the hole
in the Y-connector over the threaded
screw. Secure with attachment knob (J).
How to use
Step 1: Plug the light into any 120 Volt standard
receptacle. The on/off switches are locat-
ed on the back of each fixture head and
are independent from each other. Depress the switch once to
turn the light on; depress the switch again to turn the light off.
Step 2: The lights can be rotated in a forward,
backward, left, or right angle as needed
for light direction (K).
Step 3: Adjust the tripod stand to the desired
height by loosening and tightening the
locking collars on the pole (L).
1 4
G
H
J
K
