protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an ex p e rienced radio/TV technician for help.
• Fixture must be connected to a 120 Volt, 60 Hz power source.
Any other connection voids the warranty.
• Keep away from flammable objects.
• The electrical system, and the method of electrically connecting the
fixture to it, must be in accordance with the National Electric Code
and local building codes.
• Disassembly of the fixture will void the warranty.
• Use only a 65 watt, PL type fluorescent bulb. Use of any other bulb
will damage the fixture and void the warranty.
WARNING: Deviation from the assembly instructions may result in a
risk of fire or electric shock.
SAVE THESE INSTRUCTIONS.
Important: Read Before Using!
Remove cardboard insert that is protecting bulb before use.
Step 1: Loosen the knob (turn counter-clockwise) located on the back
and top of the fixture (F).
Step 2: The doorframe and lens assembly will swing down allowing
access to the bulb. Remove the cardboard insert. Then see
"Installing the bulb."
Step 3: Replace the door frame and lens assembly and secure it by
tightening the knob that was loosened in Step 1.
Step 4: Repeat process for second fixture head.
Installing the bulb
Step 1: Loosen the knob (turn counter-clockwise) located on the back
and top of the fixture (F).
Step 2: The doorframe and lens assembly will swing down allowing
access to the bulb. Remove the new fluorescent bulb from its
package.
Step 3: Push one of the plastic bulb retainer clips open and carefully
1 3
