Cleaning And Care - Sanitas SZA 50 Instrucciones Para El Uso

2. Rinse your mouth out with water before cleaning your teeth.
3. Moisten the toothbrush and apply toothpaste.
4. To avoid splashing, hold the toothbrush at an angle to the tooth surface. Only then
switch on the easy grip electrical toothbrush by pressing the ON/OFF switch (1). The
easy grip electrical toothbrush automatically switches to the highest speed level (High
Speed).
5. By repeatedly pressing the ON/OFF switch (1) you can select between: high speed, low
speed or massage effect.
6. Slowly go from tooth to tooth starting with the outside surface. Then clean the back
surfaces of the back teeth, then the inside surfaces and finally the occlusal surfaces. To
protect your gums and teeth avoid brushing with excessive pressure.
7. An acoustic vibration signal sounds after 2 minutes of cleaning. Press the OFF button
(2) to switch off the easy grip electrical toothbrush.
8. Remove the brush from your mouth. Rinse your mouth out well with water.
Replacement brush heads are available in retail or from our customer service.Use the
instrument only with the accessories provided.

7. Cleaning and care

Cleaning brush heads and the easy grip electrical toothbrush
WARNING
• Never use aggressive solvents or cleaning agents.
• Never immerse the device in water. Do not put the device in the dishwasher.
Clean the brush head and easy grip electrical toothbrush each time after use.
1. Rinse the brush head under running water. Here the brush is attached to the toothbrush
and the toothbrush is switched on (
2. Remove the brush head from the toothbrush and wash the brush well under running
water (
Figures 5 and 6)
3. Separately rinse the tip of the toothbrush under running water while it is switched on
( ).
Figure 7
4. Dry both parts well.
Figure 4
Cleaning the charging station and brush holder
WARNING
The changing station with cord and plug must not be submerged in water and
must be protected from all forms of moisture.
Clean the charging station and brush holder from time to time.
1. Disconnect the charging station from the power supply.
Figure 4
.
Figure 5
). Be careful about any splashing water.
Figure 6
12
Figure 7