LF garden treasures WXF02971 Manual Del Usuario página 4

10. Always unplug the fountain pump and any other independent electrical accessories (e.g lights)
from the outlet when not in use and before cleaning or replacing parts.
11. Disconnect the power cord from the outlet by holding the plug, not by pulling on the power cord.
12. Periodically change the water. Clean the fountain water basin, the pump's outlet nozzle and
the water tube for dirt and debris with a damp cloth if necessary.
13. Do not expose the pump to direct sunlight or to low temperatures for any period of time.
14. Keep the power cord away from high temperatures or heat sources.
15. Use only a UL-approved extension cord of the correct rating to avoid overheating.
16. Only use fountain parts provided by the manufacturer.
17. Do not use the pump for anything other than its intended use.
18. This fountain pump is not intended for commercial use.
CAUTION
• The pump has been evaluated for use with fresh water only.
• Risk of electric shock. Do not remove cord and strain relief. Do not connect conduit to pump.
• Do not use the pump in water exceeding 86ºF.
• Do not use the pump in flammable liquids.
• Do not use the pump for industrial purposes.
• Do not use the pump in vehicles or on board ships or aircraft or swimming pools.
• Do not use the pump in location where special conditions prevail, such as the presence of a
corrosive or 4 explosive atmosphere (dust, vapor or gas).
• Do not let the pump run dry. Pump must be completely submerged for proper operation and
cooling.
• Do not lift the pump by its power cord.
• Keep the plug dry. Do not expose the plug to water or steam.
• Before connecting to the power source, make sure the pump is assembled and completely
submerged in water.
• Always disconnect the pump from the power source before performing any maintenance on the
pump, lights (if equipped), or fountain.
• Do not exceed the voltage shown on the pump.
• Check the water level regularly to ensure the pump is completely submerged during operation.
The pump should be fully submerged during operation. Do not add water while operating the
product. Always disconnect the pump from the power source before adding water.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Phillips Screwdriver
Lowes.com/gardentreasures
4