Product Specifications; Safety Information - Utilitech 148013 Manual De Instrucciones

PRODUCT SPECIFICATIONS

Power supply required ...........................................................................115 volts or 230 volts, 60 Hz
(Pump is set by the factory to run on 115 volts)
Maximum water temperature ...........................................................................................77°F (25°C)
Individual branch circuit required ............................................................................ 15 Amp minimum
Discharge connection ..........................................................................................................1 in. NPT
Suction connection ........................................................................................................1-1/4 in. NPT
Motor duty..................... Continuous duty with enforced air cooling and thermal overload protection
Pressure switch ........................................................................... Preset at 20 PSI "on" / 40 PSI "off"
Water depth rating ................................................................................................. Maximum of 25 ft.
ITEM # MODEL #
0955552 148013

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install
the product.
• NOTE: Pumps with the "UL" Mark and pumps with the "US" mark are tested to UL Standard
UL778. CSA certified pumps are certified to CSA Standard C22.2 No. 108. (CUS.)
DANGER
• ELECTRICAL SHOCK HAZARD.
Always disconnect power source before performing any work on or near the motor or its
connected load. If the power disconnect point is out-of-sight, lock it in the open position and tag it
to prevent unexpected application of power. Failure to do so could result in fatal electrical shock.
• ELECTRICAL SHOCK HAZARD.
Do not handle the pump with wet hands or when standing in water as fatal electrical shock could
occur. Disconnect main power before handling unit for ANY REASON!
• RISK OF ELECTRIC SHOCK.
These pumps have not been investigated for use in swimming pool areas.
WARNING
• ELECTRICAL SHOCK ALERT.
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
• ELECTRICAL SHOCK ALERT.
Replace damaged or worn wiring cord immediately. Never use an extension cord.
• ELECTRICAL SHOCK ALERT.
Do not kink power cable and never allow the cable to come in contact with oil, grease, hot
surfaces, or chemicals.
HP VOLTAGE HZ
1/2 115/230 60
CAPACITY - U.S. GALLONS PER
MINUTE AT DISCHARGE 20 PSI
AMP
0 FT.
9.5/4.8 11
2
5 FT. 15 FT. 25 FT.
9.5 6.5 3.5