Extended Menu; Problems And Possible Cause - Fagor Surf Pro 6 Guia De Inicio Rapido

The DC pass is short-circuitable. If there is a short-circuit
the led blinks every second.
Press to validate and return to the main menu.
OK
1.6. Save and exit.
Press to validate and return to the presentation screen.
OK
Surf Pro 6 automatically stores the data programmed after
5 minutes of having modified any parameter.

2. Extended menu

From the presentation screen hold the
during 5 seconds, the display shows the symbol
the left corner when this function is entered.
2.1. Save configuration "* S VE CONFIG"
The UCF 300 Control unit allows saving up to 8 settings
and identify them with a name of 9 letters.
To save a configuration it must be previously memorized
in the Surf Pro 6.
2.2. Load configuration "* LO D CONFIG"
The UCF 300 Control unit allows any memorized configura-
tion to be copied into another Surf Pro 6.
3. Reset
Pressing simultaneously the keys
function is activated to delete the programming, resetting all
parameters to factory default.
Table 1: Configuration UHF Inputs / Filters
Inputs
UHF1 UHF2
6 0
4 2
3 3
Table 2: Operative output level
Nº of nalogic channels, UHF+VHF+ ux 6
RF output level
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
INDOOR USE ONLY.
key pressed
OK
"*" in
J J
and the RESET
L
M
Filters
6
8 10 16
109 108 107 105
I
UCF 300
djacent to
Input
Filter 2
ttenuator ON
Adj02 U2AT
F01 CH24 30
Filter Nº Channel Gain

4. Problems and possible cause

Effect Possible cause
There is no longer a The programming
signal being delivered of a filter or the
to output. configuration of UHF
inputs has been
changed.
The channel configu- The programmed
ration programmed in configuration has not
the SURF PRO is not been memorised in
saved in the UCF 300. the SURF PRO.
Poor output quality in Very high input level.
all channels.
Excess output level.
Low level "L" is Signals with high
indicated on a filter levels on other filters
but the input signal connected to the
level is correct. same UHF input.
9
OK
ction
Charge the UX input
with 75 Omh and
re-adjust the output
level.
Carry out point 1.6
in the manual.
See input levels in
Main Characteristics,
page 2 of the manual.
See points 1.2 and
1.4 in the manual and
comply with the
values in Table 2.
Distribute the antenna
signal and connect
the filter to the UHF
input where high
level signals are not
processed.