Cleaning The Device; Electrodes; Cleaning The Electrodes Cord; Maintenance - Hydas 4509.1.00 Instrucciones Servicio

• Wash the area of skin where you will be placing the electrodes, using mild soap and water before applying

electrodes.

• Be sure to rinse soap off thoroughly and dry skin well
• Excess hair may be clipped with scissors; do not shave stimulation area.
• Wipe the area with the skin preparation your clinician has recommended. Let this dry. Apply electrodes as
directed.
• Many skin problems arise from the "pulling stress" from adhesive patches that are excessively stretched
across the skin during application. To prevent this, apply electrodes from centre outward; avoid stretching
over the skin.
• To minimize "pulling stress", tape extra lengths of lead wires to the skin in a loop to prevent tugging on
electrodes.
• When removing electrodes, always remove by pulling in the direction of hair growth.
• It may be helpful to rub skin lotion on electrode placement area when not wearing electrodes.
• Never apply electrodes over irritated or broken skin.

7.2 | Cleaning the device

• Remove the battery from the device every time when you clean.
• Clean the device after use with a soft, slight moistened cloth.
• In case of more extreme soiling you can also moisten the cloth with mild soapy water.
• Ensure that no water penetrates into the device.
• Do not use any chemical cleaners or abrasive agents for cleaning.
7.3 | Electrodes
• It may be helpful to improve repeated application by spreading a few drops of cold water over the
adhesive and turn the surface up to air dry. Over Saturation with water will reduce the adhesive
properties.
• Between uses, store the electrodes in the resealable bag in a cool dry place.

7.4 | Cleaning the electrodes cord

• Clean the electrode cords by wiping them with damp cloth.

7.5 | Maintenance

• Maintenance and all repairs should only be carried out by an authorized agency.
• The manufacturer will not be held responsible for the results of maintenance or repairs by unauthorized
persons.
• The user must not attempt any repairs to the device or any of its accessories.
• Please contact the retailer for repair.
• Opening of the equipment by unauthorized agencies is not allowed and will terminate any claim to
warranty.
• Check the unit before each use for signs of wear and/or damage.
• Replace wear items as required.

8 | Troubleshooting

If your device does not seem to be operating correctly, refer to the chart below to determine what may be
wrong. Should none of these measures correct the problem, the device should be serviced.
Problem
The power cannot be
turned on
The output intensity
turns off
Case
The batteries are inserted in wrong
direction
1) The pads are not propper
attached to the skin
2) Pads are removed from the skin
3) The batteries are worn out
Remedial Action
Insert the batteries in correct
direction
1) If the pads are not attached
propper to the skin, the output
intensity will turn off automatically
2) If the pads come off from the skin,
the power will turn off
automatically
3) Replace the batteries with new
ones
23