Vortice ARIETT I Folleto De Instrucción página 9

!
Precaution:
• Do not make any modifications of any kind to the
product.
• The appliance must not be exposed to atmospheric
conditions (rain, sun, etc.).
• A professionally qualified person must install the
appliance.
• Perform periodic inspection on the unit to see that it
is free of visual defects. If any are found, do not
operate the unit and immediately contact Vortice.
• The electrical mains to which the unit is connected
must conform to the current standards.
• Since the appliance is double insulated, it does not
need to be earthed.
• The electrical power source to which the product is
to be connected must be able to provide the
maximum amount of electrical power required by the
product. If it cannot do this, contact an electrician for
appropriate remedial action.
• When installing the appliance, a multi-pole must be
used. The switch interpole distance must be no less
than 3 mm.
• The appliance must not be used to activate water
heaters, stoves, etc., nor must it extract to their
hot-air ducting.
• The temperature of the air or fumes being extracted
must not contain any greasy substances, soot,
chemical agents, corrosive agents, or mixtures that
are explosive or inflammable.
• The appliance must exhaust either directly to the
outside or into a duct reserved solely for the
appliance.
• Please ensure the performance of the fan does not
effect the performance of an open-flued appliance
as lay down in section 1, F1 Building Regulations.
The power-source data must be consistent with the
electrical data shown on the nameplate (A).
this symbol indicates that care must be taken to avoid damaging your product
• Do not cover or obstruct the unit's air intake and
outlet grilles .
• The appliance must be installed so that its impeller
is out of reach on the outlet side (as determined by
the Standard Finger Test, Fig.B) in conformance
with the current safety regulations. If this is not
possible, the relevant protection accessory must be
installed.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by a qualified
engineer.
• Should the appliance fail to operate or not operate
correctly, turn the switch to off. Contact Vortice
immediately and, if repairs are required, make sure
that original Vortice parts are used.
Ariett IT
• The timer is arbitrarily set at the factory at the
minimum value (3 minutes), but it can be set
anywhere between 3 and 20 minutes by adjusting
the trimmer (see fig. 31).
• The unit turns on automatically a few seconds
after the light is turned on and continues
operating for the set period of time after the light is
turned off.
Ariett I MHC
• When the unit is undergoing final testing the timer is
arbitrarily set at 15 minutes, but it can be set
between 2 and 22 minutes by adjusting the trimmer
RV2 (see fig. 32).
• The unit turns on automatically a few seconds after
the light is turned on and continues operating for the
set period of time after the light is turned off.
9