König Electronic VID-TRANS510KN Manual De Uso página 3

Rear view receiver:
Operation:
1. Connect the transmitter
with the AV cable to the
output of VCR, DVD or
SAT.
2. Connect the receiver
with the AV cable to the
input of TV, LCD screen
or Plasma.
3. Connect the adapter plug of the AC/DC adapter into the transmitter and the receiver
and connect the power plug into a 230 Volt wall outlet. Note: use the provided adapters
only.
4. Select on the transmitter and receiver the desired channel with the channel button. Note:
In case of possible distortion, try another channel. For optimum performance, it could
be necessary to point the transmitter and receiver to each other in an imaginary straight
line. Or replace the transmitter and/or receiver a bit, a few centimeters/inches could
already be enough to improve the sound and picture quality. If the reception is perfect,
no adjustments are necessary.
5. Turn on the connected equipment and enjoy wireless reception.
Using the remote control feature:
The 5.8 GHz system not only allows you to send audio/video from one area to another, it
also gives you the ability to control the source by using your existing remote control device.
It converts the infrared (IR) signal emitted by your remote control to a a radio frequency (RF)
signal in the UHF band at the receiver and sends it back to the transmitter where the RF
signal is converted back to the original IR signal and beamed to the audio/video source.
Use the IR cable and connect the 2.5mm plug to the input jack on the back of the transmitter
(IR). Place the IR sensor on the front of the display from the equipment that need to be
controlled. It's important to place the IR sensor as close as possible to the IR sensor, which
is behind the display, of the equipment.
1.
2.
IR sensor in front of display
3
1. DC power input (9 VDC)
2. AV output (white: audio
left, red: audio right, yel-
low: video)
3. ON/OFF switch
3.
VCR, DVD, SAT or other device