Operation; Before Startup; Water Supply; Working With Detergent - Kärcher Winner 150 Manual De Instrucciones

Operation

Description of the Appliance
The scope of delivery of your appliance is illus-
trated on the packaging. Check the contents of
the appliance for completeness when unpack-
ing.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
Illustrations on Page 2
1 High pressure connection
2 Detergent suction hose (with filter)
3 Appliance switch "0/OFF"/ „I/ON"
4 Storage for high-pressure hose
5 Carrying handle
6 Transport handle, adjustable height
7 Storage for trigger gun
8 Mains cable with mains plug
9 Connection for water supply with filter
10 Bearing wheel
11 Coupling element for water connection
12 Trigger gun
13 High pressure hose
14 Spray lance with high pressure nozzle

Before Startup

Illustration
Insert the transport wheels and lock them.

Water supply

According to the applicable regulations,
the appliance must never be used on the
drinking water net without a system sep-
arator. Use a suitable system separator as per
EN 12729 type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
10
English
Start up
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Help with faults".
In case of impurities in the supply water, a 3/4"
fine water filter must be used.
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with high pressure nozzle
For normal cleaning tasks.
Not suitable for use with detergents.

Working with detergent

Pull detergent suction hose as far as is re-
quired out of the housing.
Suspend end of detergent suction hose in a
container filled with detergent.
Detach spray lance from the trigger gun.
Work only with the trigger gun.
Note: This will mix the detergent with the wa-
ter stream.
Recommended cleaning method
Spray the detergent sparingly on the dry sur-
face and allow it to react, but not to dry.
Spray off loosened dirt with the high-pres-
sure jet.