Tabla de contenido
Idiomas disponibles
Idiomas disponibles
When first used, the iron may give out a little smoke. This transitory effect is perfectly normal and will disappear
very soon.
Set thermostat knob (M) on the desired temperature.
When the indicator light (l) comes on for the second time, it means that the iron has reached the required temperature and
is now ready for use.
Before applying a jet of steam to the article to be ironed, release two or three good jets of steam towards the floor to stabilise
the steam flow (Fig. 4).
Warning!
Do not release steam when the iron is standing on its grille rest (E).
If the supply of steam is reduced during ironing, it indicates that the water has fallen to its reserve level.
Shot of steam
Turn the steam adjustment knob (V) to MAX. Set the ironing temperature by turning the adjustment knob (M) past the
•••
symbol (
) and wait until the iron indicator lamp turns off. When you press the steam button (o) 3 to 5 seconds, a con-
centrated jet of steam will be delivered when the button is released.
Continuous steam
Turn the steam adjustment knob (V) to MAX. Set the ironing temperature by turning the adjustment knob (M) past the
•••
symbol (
). When the temperature is reached, press the steam button (p). The cursor (q) will lock the button, making the
jet of steam exit continuously and steadily (Fig. 6). To unlock the button (p) and stop the continuous jet, press the cursor
(q) forward (Fig. 7).
Temperature selection
First check whether the fabric has a label containing ironing instructions and compare the symbol with the instructions
which follow.
If there is no label with instructions, but you know the type of material, follow the instructions below.
note that these instructions refer to fabrics which have not been treated with starch or similar substances. If they have, they
should be ironed at a lower temperature.
Steam adjustment
This appliance is equipped with a knob (V) that lets you adjust the amount of steam from minimum to maximum, according
to the ironing needs.
Manometer
The product has a manometer (U) that indicates the steam pressure inside the boiler. If the hand points to the symbol ( )
during use, this means that the water in the boiler is almost depleted. Fill it up following the instructions provided in the chapter
"Filling the boiler during use".
Filling the boiler during use
Always check the level of water in the tank while you are ironing.
Add enough water to the tank so that the water level is always visible. Don't exceed the MAX limit.
When the water in the tank reaches the minimum level of visibility, the appliance still has a 15-minute ironing autonomy
since the tank – which is only partially visible – still contains water. Should the water run out a vibration and a louder sound
will be heard. Turn off the appliance by pressing the switch (B) and (S). Disconnect the power supply cable from the socket-
outlet.
If the appliance is not turned off promptly, the pump's heating may cause the appliance to be momentarily stopped.
It is therefore necessary to turn off the iron, fill the tank and wait at least an hour and a half until the appliance cools
down and resumes normal operation.
lift the cap (F) and pour water into the tank using the water measuring cap (G), while being careful to not exceed the MAX
limit. replace the cap (F). Connect the appliance to the power supply and press the iron on-off switch (B) and (S).
If the iron has not been used for some time (several weeks), before ironing it is advisable to hold it in a horizontal position
and operate the steam supply button (o) for about 30 seconds to clean the internal steam ducts.
Warning!
never release the steam when the iron is on its stand (E).
10
Tabla de contenido
